The world of woodworking ranges from creating benches to bridges and everything in between. That means there is a huge cache of knowledge out there just waiting for you to tap into it. Take your time and read this article in full to learn some new tips and tricks.
Woodworking can be expensive. The actual wood is one of the most expensive parts of any project. The rest of the cost is usually labor, glue and hardware. Sometimes you can save some money by buying a cheaper grade of wood for areas of your project that are not visible. Areas like drawers, backs and bottoms are excellent places to use this wood.
You can use tape to catch excess glue. If you want to prevent oozing glue stains along joints, try clamping pieces together without using any glue. You just put tape on your joint, and then cut along it using a sharp blade. Separate your pieces, and then apply glue. After that, clamp them to each other again. Your glue will ooze on the tape instead of the wood. You can peel off the tape before your glue dries.
In a pinch, you can use a hacksaw blade as a makeshift compass. Often you can’t find a compass when you need it in room, when you are away from your shop. You can quickly nail a hole in the middle of a hacksaw blade, then steady the pencil against the proper tooth to get the right length. Draw that circle.
If you have been doing woodworking for some time now you may want to think about using your skills to make your own furniture. If you already have all that you need you could even do this as a service to those that are less fortunate than you. It is a great way to share your passion with others.
When learning a new woodworking technique, practice it over and over again. Repetition is the best way to learn these skills. So find some cheap wood (scrap wood works), and go at it for some time to hone your skills. This will make it so you’re less likely to make mistakes during important projects.
Visualize your woodworking project from start to finish before taking any tool to the wood. Let your brain and imagination help you get used to what you’re about to do. In fact, when you visualize, you’ll be much less likely to make costly mistakes during the middle of a project.
Before you pull out the glue, make sure the pieces you want to glue fit together properly first. You could cause damage if you tinker with the fit after you’ve applied the glue. You can figure out what goes where with a dry fit.
Stir, never shake stains and finishes before use. Over time, these settle, so mixing is necessary. Shaking, however, adds bubbles and doesn’t always mix the stain or finish thoroughly. Stirring mixes the products better by evenly mixing in any settlement that occurred during storage. Stains and finishes that are not mixed thoroughly will not apply correctly to the wood you’re staining and are at risk of looking blotchy.
If you find that there is rust on any of your woodworking tools there is a rather easy solution. As long as the rust is just on surface, all you need to do is use a pumice stone on the spot. Be sure to scrub gently, as being too rough can lead to you damaging the tool itself.
Whatever you do when it comes to woodworking, it is important that you take the time necessary to learn as much as you can. Read articles written by experts, like this one, and learn from your peers. The more you know, the better your projects will end up once done.