Finding your place in woodworking is such a great feeling. Woodworking is very enjoyable. This article will give you some great advice about it. Keep reading to find out all about woodworking, and prepare yourself for the fun that lies ahead.
Reusable sanding blocks save you time and money. To make them all you need is a few pieces of scrap lumber. Cut a piece of 2×4 into a rectangle approximately 2 inches wide and 4 inches long. Cut a piece of sandpaper the size of your block. Then, spray one side of the piece of lumber with spray adhesive and adhere the sandpaper to the block of wood.
Make sand blocks that you can reuse. Cut six blocks from any 3/4″ plywood you have, for each sandpaper grit you regularly use. Your blocks should be 2.5 x 4.75. Put adhesive spray on the blocks and your cork tile square. Stick a block to the cork, making sure to cut the cork flush with a utility knife. Use spray glue on sandpaper and stick it to the block. Finally, cut your sandpaper flush with your cork, and then label each of your blocks.
Keep all of your woodworking tools in a safe and dry place. You want to be sure that your tools are not in reach of children, as well as that they will be safe from moisture and other elements that can cause them to degrade at high rate. Follow this rule and your tools will last a long time.
When trying woodworking for the first time, opt for cheaper woods or even scrap woods. You are going to make mistakes along the way when you are first starting. Make sure you make those mistakes on wood that’s easily replaceable. There’s nothing worse than making a rookie mistake on a very expensive piece.
Unless you are charging it, never leave your tools plugged in and unattended. You never know who might approach your tool, accidentally setting it off. Not only can this damage the items around it, but the person could be hurt and you could be left liable for the end result.
Do not make the mistake of buying woodworking supplies based on the price alone. This can turn out to be a mistake that will cost you more in the end. If the supplies you buy are not very good quality, they will wear out sooner than more expensive tools, which means you will have to replace them much sooner.
Many people use utility knives to cut veneer. This can be very dangerous; however, take heart, there is a better way. When cutting veneer, consider using a rotary cutting tool. These inexpensive tools can be purchased in your local fabric shop. Rotary cutting tools allow you to trim veneer to the perfect size.
If you are cutting, sanding, or finishing something small, get out your hot glue gun. Affix the item you are working on to the end of a pedestal stick. Hot glue holds better than a clamp, and small objects are impossible to clamp anyway. Just be careful when pulling the piece off to avoid tearing the back side of the wood.
Learn about using pilot holes. This is pretty simple to do. When driving a screw or hammering a nail into a little piece of wood or getting pretty close to the edge of a piece, it tends to split. Sometimes it’s unavoidable to put a fixing into a place like this. However, drilling a hole through the joint that’s a bit smaller than the fixing can prevent it from splitting.
Perfect is not an expectation you must retain when working with wood. Your pieces are personal and they will have character. The more you practice, the better you will get, so remain patient.