When it comes to woodworking, as a hobby or as a job, everyone can get involved. Whether building a birdhouse or a mansion, or creating a fence or filigree, there is a level of participation anyone can enjoy. Learning all you can about the field is key, so start by reading all of the great tips in this article.
Reusable sanding blocks save you time and money. To make them all you need is a few pieces of scrap lumber. Cut a piece of 2×4 into a rectangle approximately 2 inches wide and 4 inches long. Cut a piece of sandpaper the size of your block. Then, spray one side of the piece of lumber with spray adhesive and adhere the sandpaper to the block of wood.
You can use tape to catch excess glue. If you want to prevent oozing glue stains along joints, try clamping pieces together without using any glue. You just put tape on your joint, and then cut along it using a sharp blade. Separate your pieces, and then apply glue. After that, clamp them to each other again. Your glue will ooze on the tape instead of the wood. You can peel off the tape before your glue dries.
Become more accurate by using a drafting square. If you need an accurate square that’s about 2″ to 3″, you have limited options. Drywall squares tend to be very inaccurate. With carpenter squares, you have to hook them onto your work piece’s edge. A drafting square can be easily used if you happen to have one lying around. If you don’t, they are pretty cheap to find at art stores. They are incredibly accurate and as useful as a tape measure.
It’s crucial that you never try to use fingers or hands as a guide when cutting wood. Instead, a long and thin piece of scrap wood should be used to push your piece through your saw. This keeps your fingers safe, which of course are vital for living as well as the continuation of your wood working projects.
Visualize your woodworking project from start to finish before taking any tool to the wood. Let your brain and imagination help you get used to what you’re about to do. In fact, when you visualize, you’ll be much less likely to make costly mistakes during the middle of a project.
Glue can cause nasty stains on your finished work. You can eliminate stains easily using a piece of tape. First, clamp your wood together without any glue. Put a piece of tape over the joint. Cut the tape on the joint with a sharp knife. You can now clamp the wood together with glue and any excess will ooze onto the tape, not the wood.
Did you know that the teeth on a hacksaw face forward? Many people do not know this. It is the opposite of a wood saw. These saws are supposed to cut when pushed forward. Many times the blades are not labeled for correct installation. If this is the case, remember to put the teeth facing forward.
Never cut any pieces of wood without checking for nails, screws and other metal. While donning a pair of goggles keeps your eyes protected, you are still at risk for other injuries. Inspect every piece of wood whether you are re-purposing it or using new lumber. You are better safe than sorry with this safety tip, and checking the boards only takes a few minutes of your time.
With all of this great information in mind, you are ready to build anything your mind can dream up. Use these tips one by one to make woodworking the amazingly enjoyable experience you’ve yearned for. In time, you will find that you get better at it and the items you produce become exceptional.
Leave a Reply