Woodworkers have always been valued workers because their skill is needed in so many areas. There are so many things that can be made by woodworkers. There are also beautiful works of art that are created by woodworkers that are prized by many collectors, museums and galleries. here are some tips to get you started in the fascinating world of woodworking.
Make sure your workbench is the proper height. It really can make a big difference. It needs to fit you and how you work. Usually if you are around 5’6″ to 5’9″ you probably need one that is between 33″ and 36″ high. If you are 5’10” or taller, you may need one that is between 35″ and 37″ high. Use your bench at its current height to determine if you need to change it to work better for you.
Check out your local library for books on woodworking. You will likely find books that contain tips, special skills or even step-by-step guides that can take you from start to finish on a project. A library can be wonderful source of information that people tend to forget when they are looking for knowledge, so do not let this resource slip your mind.
Always follow the owner’s manual when using one of your woodworking tools. Not knowing the manual’s recommendations can result in injury or failure of your tool, and you surely do not want either of these to happen to you. If you have not yet read your manuals do so right away!
Learn how to find the center in a piece of firewood every time. Mount some flat scrap wood to the lathe’s faceplate. Attach an acrylic piece to it using some double-faced tape. Chuck that in your lathe. Turn your acrylic to a disc. Using a 1/16″ bit in your tail stock chuck, drill a hole through that center-point. Scribe some concentric circles on to the disc at 1/2″³ intervals using a skew chisel. Position this center-finder over the end of your stock and adjust it until one of your circles is inscribed completely in a portion of the wood that is solid and usable. Using an awl or nail set, mark your center through the central hole in the disc.
If you plan on applying any gloss or stain to a piece of wood, it is very important that you sand it down first. Failing to do this step will result in a wood surface that is not very smooth. Use sandpaper to smooth things down then make sure all dust s removed by brushing it with a cloth.
Learn about using pilot holes. This is pretty simple to do. When driving a screw or hammering a nail into a little piece of wood or getting pretty close to the edge of a piece, it tends to split. Sometimes it’s unavoidable to put a fixing into a place like this. However, drilling a hole through the joint that’s a bit smaller than the fixing can prevent it from splitting.
Make use one of the beveled inner part of a pencil sharpener. If you mount it on a small shaft, you can use it in a drill. It a good tool for shaping smaller pieces. When it gets dull, just sharpen it on an emery cloth by running the drill on a slow speed.
As you may already know, woodworking is a highly valued skill. It can be very useful to know and can also just be an enjoyable hobby where you create beautiful works of art. If you are looking to get into doing more woodworking, then the tips above can help you do just that.
Leave a Reply