Is woodworking something you enjoy? Have you given it a shot before, or are you currently a seasoned pro? Regardless of the woodworking done, the art itself is delightful, and this piece is full of good information. Read on to learn some more about this craft.
Before you get started on any woodworking project, do some research on the type of wood you will be using. Different types of wood absorb paint and stain differently, some too much, and some not enough. If you aren’t certain about what kind of wood you will need, just ask for help.
In a pinch, you can use a hacksaw blade as a makeshift compass. Often you can’t find a compass when you need it in room, when you are away from your shop. You can quickly nail a hole in the middle of a hacksaw blade, then steady the pencil against the proper tooth to get the right length. Draw that circle.
Become more accurate by using a drafting square. If you need an accurate square that’s about 2″ to 3″, you have limited options. Drywall squares tend to be very inaccurate. With carpenter squares, you have to hook them onto your work piece’s edge. A drafting square can be easily used if you happen to have one lying around. If you don’t, they are pretty cheap to find at art stores. They are incredibly accurate and as useful as a tape measure.
Before practicing advanced woodworking techniques, make sure you’ve got the basics down. Typically those advanced techniques rely on you knowing the basics like the back of your hand. If you don’t, you’ll more than likely find learning to be a very frustrating experience. So start slow, and work up from there.
Many people use utility knives to cut veneer. This can be very dangerous; however, take heart, there is a better way. When cutting veneer, consider using a rotary cutting tool. These inexpensive tools can be purchased in your local fabric shop. Rotary cutting tools allow you to trim veneer to the perfect size.
Take advantage of several tools instead of trying to do all of your work on just one. A jig, a tablesaw, a bandsaw and a lathe all have their own uses. It is important that you know what each of these tools do and you use them accordingly while getting the job done.
If you are working with wood, it can be very dangerous to have a messy workshop. Do everything you can to keep your work area clean and well-maintained. Every time you are done with a specific tool, out it away before you get another. It may seem like this is time consuming, but you won’t have any reason to clean up later.
Do you lose drill press key chucks often? A good way to keep them within reach is to drill a hole somewhere on the drill press they fit. On top of the press is a good place, where you can see it. Drill a small hole the exact same size of the chuck’s crossbar and it will fit in perfectly.
Learn how to find the center in a piece of firewood every time. Mount some flat scrap wood to the lathe’s faceplate. Attach an acrylic piece to it using some double-faced tape. Chuck that in your lathe. Turn your acrylic to a disc. Using a 1/16″ bit in your tail stock chuck, drill a hole through that center-point. Scribe some concentric circles on to the disc at 1/2″³ intervals using a skew chisel. Position this center-finder over the end of your stock and adjust it until one of your circles is inscribed completely in a portion of the wood that is solid and usable. Using an awl or nail set, mark your center through the central hole in the disc.
If you yearn to turn rough wood into a work of art, it’s time to begin enjoying woodworking. Do not get intimidated, just focus on using this advice. It may take a bit of time and commitment to achieve woodworking greatness, but it is within your power. Woodworking can be summed up with two words: creativity and practice.
Leave a Reply