Woodworking is one of the things that separates man from the rest of the animal kingdom. Few other species demonstrate the ability to take wood and use it to create something. When you work with wood, you have the power to visualize something in your mind and then create it into a physical reality. The following paragraphs are full of tips on how to make this easier.
Practice some table saw safety. When crosscutting with a table saw, set your cut length with the block clamped to your fence. Do not use your fence directly for avoiding get kicked back by a board directly. You need to clamp the block of wood to your fence before your blade. The board’s end is free of the fence when you cut and after you cut.
Try using duct tape to create a level spot. If you’ve used your table saw on a base that’s mobile, you should be able to easily pull it in and out. To really finish it up, find a level spot on your floor. This also helps you saw boards without obstruction. Mark your wheel positions using duct tape that is brightly colored, and then roll the saw to that same flat spot each time you need to saw.
Never skip sanding when it is necessary or think that staining hides imperfections in the wood. Wood with scratches, dents and nicks absorbs much more finish or stain than wood that is smooth. When you skip sanding or do not do a thorough job of it, the imperfections stand out even more because of the increased absorption.
Visualize your woodworking project from start to finish before taking any tool to the wood. Let your brain and imagination help you get used to what you’re about to do. In fact, when you visualize, you’ll be much less likely to make costly mistakes during the middle of a project.
If you have your own table saw, you will eventually have to crosscut some wood. This can bring your fingers very close to the saw guard and blade. If the saw kicks back, you could be headed to the hospital. It is best to cut a block of wood to push the wood through the saw with.
Stir, never shake stains and finishes before use. Over time, these settle, so mixing is necessary. Shaking, however, adds bubbles and doesn’t always mix the stain or finish thoroughly. Stirring mixes the products better by evenly mixing in any settlement that occurred during storage. Stains and finishes that are not mixed thoroughly will not apply correctly to the wood you’re staining and are at risk of looking blotchy.
If you find that there is rust on any of your woodworking tools there is a rather easy solution. As long as the rust is just on surface, all you need to do is use a pumice stone on the spot. Be sure to scrub gently, as being too rough can lead to you damaging the tool itself.
If you are going to be doing a big woodworking project on the outside of your home, check to make sure it is within the rules. Your local government may have zoning regulations or even a permit process needed for structures like garages, decks and even storage sheds. Also check with your neighborhood association if there is one.
As stated in the introduction, there are scant few species that do woodworking of any kind. One of the facets of the human race that makes us distinct from lower forms of life is our ability to have a mental idea and make it a physical reality with wood. Use the ideas within this article to make woodworking one of your better personal skills.
Leave a Reply