When it comes to hobbies, few are as rewarding as woodworking. You can turn yourself a beautiful railing, create a jewelry box for your daughter or create a new dining room table which perfectly matches your renovated flooring. Regardless of the project you want to tackle, the tips below will help you find success.
Try making reusable sanding blocks by yourself. First cut 6 blocks from scrap plywood, one for each grit of sandpaper you like to use. Be certain they measure 2.5 inches across by 4.75 inches long. Use an adhesive spray on the blocks as well as your cork tile square. Put one block on the cork, and then cut it flush with a knife. Put glue on the sandpaper and apply to the cork. Finally, trim the sandpaper and label each block.
Use stop blocks to your advantage for more accurate work. When cutting a lot of pieces the same size, no matter how carefully you measure, you often find small variations. Use a pre-cut stop block to make those measurements pinpoint accurate. Then the table saw will stop at just the right length length.
Always select the correct wood for your project. When thinking of work with wood, there are some pieces of wood that aren’t able to handle the stress other woods can. If you don’t know how each wood type reacts to what you’re trying to do, spend a bit of time learning about it.
Keep the floors safe in your woodworking shop. Dust builds up on the floor, making it dangerous for walking. Coat the slippery areas of your shop with a mixture of crushed walnut shells and paint. The walnut shells are just the right consistency to keep the floor rough enough for walking, even when sawdust builds up.
Make sure your work area is safe, well-lit and organized. Working with woods is difficult work, and it is dangerous work when your work area is dim and there are safety hazards in the area. Make sure there are no spills, tripping hazards and other safety hazards that are a disaster waiting to happen.
One of the necessary tools for woodworking is the common pencil. Pencils do get lost easily, however. Buy plenty, then store them in an old instant soup container. Fill the container with sawdust and drill holes in the lid. You’ll now have plenty of pencils and the container won’t tip over easily.
If you mark your intended cuts with pencil lines, try not to actually cut them! You might be lined up at first, but it is possible to get a little off later in the cut, resulting in pieces that fit less that perfectly. It’s better to cut the edge of the pencil line and then sand the rest of the marking off.
Never allow someone to watch while you are woodworking without wearing the same gear that you are wearing. Being anywhere near the tools is a hazard, even if they are not using them. Wood or parts of the tool could fly into the air and strike them just as they could you.
Clean tools last longer; therefore, it is important to clean your tools after each use. Dip a shop rag into a small amount of acetone and wipe each tool to remove any build-up. Afterwards, dip a different shop rag into machine oil and wipe the metal of each tool to help prevent rusting.
From a tiny match box to a new deck for your backyard, working with wood provides you with tangible rewards which show how skilled you are. In order to better those skills, use the ideas mentioned here and start working smarter. In no time, you’ll find that you are able to achieve even greater results.
Leave a Reply