Woodworking is an awesome hobby that leaves you open to so many different options that it could never get old. If you find that you are in a rut when it comes to the skills that you have you should read the article below. It is full of ideas that can bring new elements into the work that you do.
Before practicing advanced woodworking techniques, make sure you’ve got the basics down. Typically those advanced techniques rely on you knowing the basics like the back of your hand. If you don’t, you’ll more than likely find learning to be a very frustrating experience. So start slow, and work up from there.
Stir, never shake stains and finishes before use. Over time, these settle, so mixing is necessary. Shaking, however, adds bubbles and doesn’t always mix the stain or finish thoroughly. Stirring mixes the products better by evenly mixing in any settlement that occurred during storage. Stains and finishes that are not mixed thoroughly will not apply correctly to the wood you’re staining and are at risk of looking blotchy.
Do you lose drill press key chucks often? A good way to keep them within reach is to drill a hole somewhere on the drill press they fit. On top of the press is a good place, where you can see it. Drill a small hole the exact same size of the chuck’s crossbar and it will fit in perfectly.
If dust and dirt get into the holes of a brad or nail gun while they are not in use, this can cause them to wear out more quickly. It is a good idea to plug the air inlet holes up with something to prevent anything from getting in there.
Always check your tools before you begin using them. Woodworking with a faulty or overused tool can easily lead to a serious injury or destruction of your materials. To make sure that this does not happen to you take the time to thoroughly inspect your tools from top to bottom.
Never cut any pieces of wood without checking for nails, screws and other metal. While donning a pair of goggles keeps your eyes protected, you are still at risk for other injuries. Inspect every piece of wood whether you are re-purposing it or using new lumber. You are better safe than sorry with this safety tip, and checking the boards only takes a few minutes of your time.
Make sure you get the right type of wood. Don’t use woods that are soft like pine when making a table top; soft woods scratch easily. Wood will turn into different colors upon finishing.
When you need to finish, sand, shape, file or cut a small item, you may wish to glue it to a pedestal stick rather than attempting to clamp it. Clamps can be cumbersome when doing fine work, and sometimes, it is not even possible to use a clamp. A dot of hot glue will hold your small piece in place, and you can simply pop it free using a putty knife when finished.
Stain only provides color to wood, not finish. You will need to apply a finish coat on top of the stained wood. If you are in a hurry, or short on time, you can use a product that combines both stain and finish together. Be sure to use a higher-quality brush for this, and stain in the direction of the grain.
Now that you have read the article above you surely have realized that you have so much more available to work with than you thought before. The key to keeping your hobby interesting is to continue to learn about your options, just as you have by reading the above article. Now get out there are put the above tips to work.
Leave a Reply