The world of woodworking ranges from creating benches to bridges and everything in between. That means there is a huge cache of knowledge out there just waiting for you to tap into it. Take your time and read this article in full to learn some new tips and tricks.
You can make your own reusable sanding blocks. You will need three-quarter-inch plywood cut into six blocks. Be sure to create a block for each of the sandpaper grits you typically use. They should be able two and a half inches by four and three-quarters inches. Apply spray adhesive to both the blocks and the cork tiles. Put one block on the cork, and then cut it flush with a knife. Put adhesive on the sandpaper sheet and then apply it to the cork blocks face down. At the end, trim the sandpaper and label each block.
Become more accurate by using a drafting square. If you need an accurate square that’s about 2″ to 3″, you have limited options. Drywall squares tend to be very inaccurate. With carpenter squares, you have to hook them onto your work piece’s edge. A drafting square can be easily used if you happen to have one lying around. If you don’t, they are pretty cheap to find at art stores. They are incredibly accurate and as useful as a tape measure.
Always wear safety glasses when you are doing anything that involves woodworking. If you do not take the time to put the glasses on you are taking a huge risk that is not sensible. Just think, if you lose your eye sight you will not be able to do woodworking every again.
Do not use your fingers to guide a narrow strip of wood into the saw. Use a piece of thin wood instead to help push along the piece. This will keep you from cutting off a finger, which is what you don’t want to happen if you’re wishing to do woodworking again.
When you are new at woodworking and starting to collect your tools, purchase simple tools to begin with. Try your hand at a few projects to make sure you want to continue before you invest in expensive tools. You can save money and get better quality tools when you buy used tools.
Take baby steps when first starting out with woodworking. It’s a lot of fun to learn, but woodworking is also pretty dangerous if you get too cocky too soon. Even when you feel like you know the basics, keep practicing them. And always where safety gear. You are much better off.
Did you know that the teeth on a hacksaw face forward? Many people do not know this. It is the opposite of a wood saw. These saws are supposed to cut when pushed forward. Many times the blades are not labeled for correct installation. If this is the case, remember to put the teeth facing forward.
Do you hate those bubbles that form when applying joint compound to your drywall? There is a simple trick that professional drywallers use to avoid this annoying problem. Add two or three drops of dish detergent to your joint compound and you will be rewarded with bubble free joint compound.
You can apply stain with either a brush, or a rag. Work the stain in against the grain, and with it as well. You need not be neat, just get a smooth, even coat on the wood. Then, wipe immediately for a lighter tone, or leave it on for up to fifteen minutes before wiping for a deeper tone.
Whatever you do when it comes to woodworking, it is important that you take the time necessary to learn as much as you can. Read articles written by experts, like this one, and learn from your peers. The more you know, the better your projects will end up once done.