Whether you are a novice woodworker or a seasoned professional, you probably understand that knowledge is the key to working with wood. Woodworking still requires an ample amount of skill as well; however, without information and learning, those skills may not do you an good. This article hopes to pass on some great suggestions to help you enjoy woodworking.
Reusable sanding blocks save you time and money. To make them all you need is a few pieces of scrap lumber. Cut a piece of 2×4 into a rectangle approximately 2 inches wide and 4 inches long. Cut a piece of sandpaper the size of your block. Then, spray one side of the piece of lumber with spray adhesive and adhere the sandpaper to the block of wood.
Use stop blocks to your advantage for more accurate work. When cutting a lot of pieces the same size, no matter how carefully you measure, you often find small variations. Use a pre-cut stop block to make those measurements pinpoint accurate. Then the table saw will stop at just the right length length.
Clean your saw’s teeth before cutting lumber. To thoroughly clean your saw blade dip a shop rag into a little acetone and wipe the blade thoroughly. Additionally, using a piece of sandpaper that has a fine grit will remove any sap or gumminess from your skill saw’s cutting blades.
When trying woodworking for the first time, opt for cheaper woods or even scrap woods. You are going to make mistakes along the way when you are first starting. Make sure you make those mistakes on wood that’s easily replaceable. There’s nothing worse than making a rookie mistake on a very expensive piece.
Before practicing advanced woodworking techniques, make sure you’ve got the basics down. Typically those advanced techniques rely on you knowing the basics like the back of your hand. If you don’t, you’ll more than likely find learning to be a very frustrating experience. So start slow, and work up from there.
Always be on the lookout for good woodworking tips. If you meet professionals, ask them for their best tips. If you find a magazine chock full with tips, pick it up so that you can keep it in your archive. Even record TV shows that have woodworking in them to glean any tips you my find there.
Go to yard sales, garage sales, and online to get better deals on woodworking equipment. You can often get great tools at a fraction of the price if you don’t buy them new. That will help you put more of your money into the projects you create instead.
Do you know that different colored tin snips make different kinds of cuts? Tin snips with red handles are used for making left hand turns. Green handled tin snips are used for making right hand turns. Finally, yellow handled tin snips are used for straight lines and gradual curves.
Always disconnect the power of your power tools before you change blades or do any maintenance work on it. It is very dangerous to leave the electrical tool plugged in when you change blades. If the tool turned on, it would be a catastrophe. Always remember this tip to stay safe while woodworking.
When working on heaving woodworking machinery, like a band saw, or a lathe, keep distractions to a minimum. One slip can cause the ruin of your project. No only that, but you can get injured as well. Always pay 100% attention to what you are doing and keep your eye on your work.
It is hard to imagine a world without woodworking. Those that can shape simple wood into imaginative or useful pieces are often sought after. If you hope to be successful with woodworking, or just boost your knowledge, it is hoped that this article has given you proper insight into enjoying working with wood.
Leave a Reply