Sadly, there just isn’t a lot of advice out there when it comes to working with wood. You may dream of crafting a beautiful chair or table, but how do you begin. This article was written with you in mind, offering tips and tricks you just won’t find elsewhere, so read on.
Use stop blocks to your advantage for more accurate work. When cutting a lot of pieces the same size, no matter how carefully you measure, you often find small variations. Use a pre-cut stop block to make those measurements pinpoint accurate. Then the table saw will stop at just the right length length.
When you are working on a project, be sure to face your light directly on your working area. The bright light will enable you to detect any drips or runs you may not see otherwise. Missed areas will also be more visible. Be sure to always work in a well-ventilated area as well.
When sanding a piece of lumber, a lot of sawdust and debris is produced. To help remove those bits of dust and debris from your project vacuum the area. Then, remove the remaining debris using a tack cloth. Wipe both sides of the lumber to remove all traces of debris for best results.
When sanding a piece of lumber, beginning with a coarse sandpaper. Remove the excess dust from the lumber. Then, once the largest scratches are removed, sand again with a smoother sandpaper. Follow this sanding with a tack cloth. Continue using smoother sandpaper until the lumber feels smooth when you run your hand across it.
Always remember the rule of measuring twice and cutting once. You are human, which means that mistakes are inevitable. However, you can prevent measurement mistakes from turning into cutting mistakes when you measure two or three times. That is going to spare you serious waste, not just in terms of wasted wood, but also money and time.
When you find a nice level spot on your workshop floor for your table saw, it can be difficult finding the same spot after you put your saw away. When you do find a level spot, use duct tape on the floor so you know where to position your table saw next time you need it.
Do you find that your joint compound seems to dry out in between uses? There is a simple fix to help keep your joint compound moist. Simply pour a small amount of water on top of your joint compound before sealing it. The next time you need to use the joint compound, drain off the excess water and your joint compound will be perfectly moist.
Use recycled wood when available. Discarded scraps are a great find so keep your eyes open. Flooring stores and home improvement shops are always tossing away unused wood. Use this to your advantage and keep an eye out for pieces you can use. This also saves quite a bit of money.
When deciding on a woodworking project, make sure you know what tools will be required to finish the project. If you are missing a tool, you may have to stop in the middle of the project and never finish. Many tools are available for rent at home improvement stores, but some you may have to purchase. This purchase could bring you well above your budget.
With all of this advice fresh in your mind, the time is now to tackle the world of working with wood. Any project you have dreamed of creating is now within your reach. Take your time as you review each tip and start to use it as you build your first project and the results will be astounding.
Leave a Reply