This article can help fine tune your woodworking skills. This article will give you ideas no matter how skilled you are. If you want to push your personal woodworking horizons, then take the time to finish this article.
Become more accurate by using a drafting square. If you need an accurate square that’s about 2″ to 3″, you have limited options. Drywall squares tend to be very inaccurate. With carpenter squares, you have to hook them onto your work piece’s edge. A drafting square can be easily used if you happen to have one lying around. If you don’t, they are pretty cheap to find at art stores. They are incredibly accurate and as useful as a tape measure.
Whenever you work with wood, wear a pair of safety glasses and a dust mask to keep yourself safe. When cutting or even hammering into wood, pieces can fly up into your eyes or be breathed in. This can lead to health issues which can end your enjoyment of this pursuit for good.
When learning a new woodworking technique, practice it over and over again. Repetition is the best way to learn these skills. So find some cheap wood (scrap wood works), and go at it for some time to hone your skills. This will make it so you’re less likely to make mistakes during important projects.
If you are going to be doing a big woodworking project on the outside of your home, check to make sure it is within the rules. Your local government may have zoning regulations or even a permit process needed for structures like garages, decks and even storage sheds. Also check with your neighborhood association if there is one.
Do you find that your joint compound seems to dry out in between uses? There is a simple fix to help keep your joint compound moist. Simply pour a small amount of water on top of your joint compound before sealing it. The next time you need to use the joint compound, drain off the excess water and your joint compound will be perfectly moist.
Learn about using pilot holes. This is pretty simple to do. When driving a screw or hammering a nail into a little piece of wood or getting pretty close to the edge of a piece, it tends to split. Sometimes it’s unavoidable to put a fixing into a place like this. However, drilling a hole through the joint that’s a bit smaller than the fixing can prevent it from splitting.
If you mark your intended cuts with pencil lines, try not to actually cut them! You might be lined up at first, but it is possible to get a little off later in the cut, resulting in pieces that fit less that perfectly. It’s better to cut the edge of the pencil line and then sand the rest of the marking off.
Go to garage sales, yard sales, estate sales, or even look online for deals on any tools you need for your woodworking. You may just be surprised at how much money you can save on gently used or new tools this way. You can save lots of money this way when you are a beginning woodworker.
You make mistakes. Always remember that, but never say it. You have made mistakes in the past, you are going to make them in the future. Always treat them as learning opportunities. However, never point them out to others or talk about them. Others may not notice, or even care. They’re likely to just be impressed you did something they couldn’t.
The article you just read if full of useful tips on how to become a great woodworker. It is certain you can use what you have learned here when you start your next project. Now get started!