It’s great fun to start woodworking. It can also be confusing if you don’t know where to start. Taking baby steps to get started will take away your worries. Follow the advice presented here to begin.
Reusable sanding blocks save you time and money. To make them all you need is a few pieces of scrap lumber. Cut a piece of 2×4 into a rectangle approximately 2 inches wide and 4 inches long. Cut a piece of sandpaper the size of your block. Then, spray one side of the piece of lumber with spray adhesive and adhere the sandpaper to the block of wood.
Before using any new tool, do your research on it in full. New tools can mean serious injuries for those that use them incorrectly. Even if you’re pretty sure of how to use it, don’t risk it. Study up via the web and books related to the tool in question.
If you are bored using power tools for your woodworking project, try your hand at using classic manual tools. For hundreds of years people used no power in their woodworking. Everything was done by hand. It is a challenging way to add some excitement and pride to your next woodworking project.
Always follow the owner’s manual when using one of your woodworking tools. Not knowing the manual’s recommendations can result in injury or failure of your tool, and you surely do not want either of these to happen to you. If you have not yet read your manuals do so right away!
Always remember the rule of measuring twice and cutting once. You are human, which means that mistakes are inevitable. However, you can prevent measurement mistakes from turning into cutting mistakes when you measure two or three times. That is going to spare you serious waste, not just in terms of wasted wood, but also money and time.
Always check your tools before you begin using them. Woodworking with a faulty or overused tool can easily lead to a serious injury or destruction of your materials. To make sure that this does not happen to you take the time to thoroughly inspect your tools from top to bottom.
Keep your work area as clean as possible. Woodworking creates a lot of mess, especially dust. This dust can get into your home and eventually into your lungs. This can cause real health problems down the road for you and your family. So take a few minutes after a job, and sweep up your space.
When wiping excess stain off wood, wipe in the direction of the grain. Otherwise, the stain will just lay on top. Not only does this ensure that the stain is getting all the way into the grain, it will show off the grain of the wood to its best advantage.
Make sure there are no spots of glue on the wood before proceeding to finish your project. The spots will show up as lighter spots after the finish has been applied. You can use mineral spirits of naptha to completely remove all traces of glue from the wood. You may also be able to remove the glue by sanding the wood.
When starting out in woodworking, buy the tools you’ll need immediately. Later buy more tools as the need comes up. Don’t spend a fortune decking out a shop at first. You’ll find there are many tools you won’t ever use. You’ll also find you can often make due with the tools you already have on hand rather than spending more money.
On the road to being a master of woodworking, the advice above will be a big help. Keep learning so that you’ll really see the potential and possibilites that woodworking offers. There’s a lot that you can create!