Either you want to make things for sale or you just want to work with wood for the entertainment value. Your reasons do not matter. Woodworking is not terribly difficult, but it does take some know-how. The article below is a compilation of expert information and tips that you can put into practice immediately.
Don’t neglect sanding your wood. Sanding may be tedious, but the quality of your workmanship will suffer if you leave the scrapes and nicks where they are. Not to mention, those scratches and nicks absorb more stain and paint, making them stand out more, and making your work look shoddy.
The reason why many power tools have guards on them is to keep you safe. Never remove the guards off of any of your tools. You may not understand why they are there, but they are there for a reason. They are there to protect you from sharp blades, moving parts and other things that could potentially hurt you.
Practice some table saw safety. When crosscutting with a table saw, set your cut length with the block clamped to your fence. Do not use your fence directly for avoiding get kicked back by a board directly. You need to clamp the block of wood to your fence before your blade. The board’s end is free of the fence when you cut and after you cut.
Gel stains make staining furniture items easier. Gel stains adhere to wood better, while liquid stains run a lot more. Also, because your gel stains are a lot thicker their pigment is going to be consistent while applying it so that the stain is more even on vertical and horizontal pieces.
If you will be re-coating an existing finish, be sure that the surface is clean and free of any wax or oils. Then, let it dry completely, and lightly scuff the surface with a 220-grit sandpaper so that the finish you are applying will have something to hold onto.
When sanding a piece of lumber, beginning with a coarse sandpaper. Remove the excess dust from the lumber. Then, once the largest scratches are removed, sand again with a smoother sandpaper. Follow this sanding with a tack cloth. Continue using smoother sandpaper until the lumber feels smooth when you run your hand across it.
Do not make the mistake of buying woodworking supplies based on the price alone. This can turn out to be a mistake that will cost you more in the end. If the supplies you buy are not very good quality, they will wear out sooner than more expensive tools, which means you will have to replace them much sooner.
Glue can cause nasty stains on your finished work. You can eliminate stains easily using a piece of tape. First, clamp your wood together without any glue. Put a piece of tape over the joint. Cut the tape on the joint with a sharp knife. You can now clamp the wood together with glue and any excess will ooze onto the tape, not the wood.
Be certain your blades are sharp before you start sawing. A dull blade makes good cutting impossible. Dull blades can also cause costly errors due to damage to your wood.
Keep your tools and hardware organized. When you keep clutter to a minimum, it does more than just add discipline to your workshop. It also keeps distractions, hazards and time spent hunting down a misplaced item to a minimum. Keeping screws, nails and other hardware and accessories in one place neatly stored until needed makes your projects faster and keeps you safer.
Now that you now more about woodworking, you are ready to get started. Use what you’ve just learned, and you will do quite well. Enjoy the process as you improve your skills and make wonderful creations. You are about to find out just how much of a joy woodworking really is!
Leave a Reply