Most people don’t know much about the hobby of woodworking. They think it’s just a matter of cutting some wood, slapping it together and calling it a success. The fact is that there is more to it than that, and the tips below will guide you through the process.
In a pinch, you can use a hacksaw blade as a makeshift compass. Often you can’t find a compass when you need it in room, when you are away from your shop. You can quickly nail a hole in the middle of a hacksaw blade, then steady the pencil against the proper tooth to get the right length. Draw that circle.
Test the color of a stain before doing the complete stain on more visible areas. Wood is never predictable, so a stain may not look the way you expect or need it to when applied to the wood you are using. When you test the stain in a spot that’s not easily visible, you prevent having a project turn out badly.
If you find that there is rust on any of your woodworking tools there is a rather easy solution. As long as the rust is just on surface, all you need to do is use a pumice stone on the spot. Be sure to scrub gently, as being too rough can lead to you damaging the tool itself.
You can apply stain with either a brush, or a rag. Work the stain in against the grain, and with it as well. You need not be neat, just get a smooth, even coat on the wood. Then, wipe immediately for a lighter tone, or leave it on for up to fifteen minutes before wiping for a deeper tone.
Quickly get rid of burn marks caused by the router. Certain woods burn easily when routered and it can be very time-consuming trying to sand the marks away. If the router template is complex, it may be nearly impossible. Try just routering down further just a small amount using the same bit. About 1/32nd of an inch should take the burn marks off.
You can use woodworkers glue to secure joints if you clamp the joint securely in place while the glue dries. Many people prefer to glue the joint in addition to using fasteners. This prevents the joint from loosening if it is subjected to pressure that could cause it to give way.
Always measure twice and cut once when working with wood. Most woodworkers have heard this; however, most do not follow this advice. Simply double checking to ensure that your measurements are correct can save you both time and money. Additionally, ensure that you have an accurate tape measure for best results.
You can make a customized color of stain, but make sure the stains you are using are from the same manufacturer. Be sure that you use either all water-based stain, or all oil-based. Never mix the two. Finally, be certain to write down the exact amounts you used of each, so that the color can be duplicated if desired.
Monitor your blades periodically to make sure they stay sharp. Sharp blades on your saws can save you a lot of time when you’re woodworking. That is the reason you need to check them regularly for performance reasons. Have a schedule in place where you check regularly. That will make sure you have sharp blades when you need them.
As you learn more about woodworking, you’ll find that things become easier. You’ll be able to plan out your projects better, complete them on time and have end results which are impressive. Use this new knowledge to make your hobby the best it has ever been, time and time again.
Leave a Reply