If you’ve got a hankering to do do woodworking, you are in good company. Many people aspire to be excellent wood crafters, but few actually achieve that goal. Learning something new is always a bit intimidating, but this needn’t be. You can learn what you need to know to get started by reading the following article.
Reusable sanding blocks save you time and money. To make them all you need is a few pieces of scrap lumber. Cut a piece of 2×4 into a rectangle approximately 2 inches wide and 4 inches long. Cut a piece of sandpaper the size of your block. Then, spray one side of the piece of lumber with spray adhesive and adhere the sandpaper to the block of wood.
Tape can be your friend when gluing stained wood together. Place the two pieces of wood together in a clamp and tape the seam before applying the glue. Carefully cut the tape along the joint and then separate the two pieces of the wood and apply the glue along the joint. Clamp together and allow to dry. The tape will keep the glue off the wood and is easy to remove once the glue is dried.
Always wear safety glasses when you are doing anything that involves woodworking. If you do not take the time to put the glasses on you are taking a huge risk that is not sensible. Just think, if you lose your eye sight you will not be able to do woodworking every again.
If you enjoy doing woodworking as a hobby, try to use all the materials that you buy and throw away as little as possible. Scrap pieces of plywood or hard wood can be used as sanding blocks for future projects. You can also use scrap wood for wooden dowels in furniture making.
Stir, never shake stains and finishes before use. Over time, these settle, so mixing is necessary. Shaking, however, adds bubbles and doesn’t always mix the stain or finish thoroughly. Stirring mixes the products better by evenly mixing in any settlement that occurred during storage. Stains and finishes that are not mixed thoroughly will not apply correctly to the wood you’re staining and are at risk of looking blotchy.
When you find a nice level spot on your workshop floor for your table saw, it can be difficult finding the same spot after you put your saw away. When you do find a level spot, use duct tape on the floor so you know where to position your table saw next time you need it.
Look around for wood that is recycled. There are a lot of places that have scraps for you to use. You may be surprised to learn that many home improvement stores or other types of businesses that use wood will simply throw out any wood they don’t use. Check for pieces which might work for your project, or even just for practice. This can also save you quite a bit of money in the long run.
Never cut any pieces of wood without checking for nails, screws and other metal. While donning a pair of goggles keeps your eyes protected, you are still at risk for other injuries. Inspect every piece of wood whether you are re-purposing it or using new lumber. You are better safe than sorry with this safety tip, and checking the boards only takes a few minutes of your time.
In summary, you can achieve your woodworking goals by applying the tips above. Keep learning about the craft, and soon you will be an expert. It only takes the desire and the time to hone your woodworking skills. Soon, you’ll be making anything your heart desires and having fun to boot!
Leave a Reply