If you’re just starting out with woodworking, this article is perfect for you. You will be well on your way to enjoying the pleasures of woodworking by using the advice below. You will find out more if you keep on reading.
Organize your shop’s extension cords to keep your shop safe and tidy. You can make your own cord keeper with nothing more than a scrap piece of wood. Simply cut a piece of wood in the shape of an I and wrap each of your extension cords around the wood.
When using stain, try a test on a small scrap you may have available or in an area on the wood that will be out of sight. Testing first will give you an idea of how the stain will look on a real piece. You’ll get no unwelcome surprises later. Wood is unpredictable so you’ll want to test it first.
Keep all of your woodworking tools in a safe and dry place. You want to be sure that your tools are not in reach of children, as well as that they will be safe from moisture and other elements that can cause them to degrade at high rate. Follow this rule and your tools will last a long time.
Always put your safety first when it comes to using tools, stains and paints. The more variety you use, the more specifics there are about applications, tool use, times for drying, and more. Put your safety first by reading the instructions, wearing any necessary protective gear, and working in areas with good ventilation whenever using oil-based products or anything that produces air pollutants.
When you are working with wood it is important that you take your time. Being hasty leaves you open to making plenty of mistakes. Instead of focusing on the amount of time it takes you to complete a project, do everything you can to keep your mind on the task at hand.
Try dry fitting wood before you glue it. You could cause damage if you tinker with the fit after you’ve applied the glue. You can figure out what goes where with a dry fit.
If there is a joint in your work that does not fit together properly, this cannot be fixed with glue. While it may seem like the simple way to fix things, it will only work temporarily. The best thing to do would be to start over and be more careful the next time.
If you are working with wood, it can be very dangerous to have a messy workshop. Do everything you can to keep your work area clean and well-maintained. Every time you are done with a specific tool, out it away before you get another. It may seem like this is time consuming, but you won’t have any reason to clean up later.
When you find a nice level spot on your workshop floor for your table saw, it can be difficult finding the same spot after you put your saw away. When you do find a level spot, use duct tape on the floor so you know where to position your table saw next time you need it.
Learn how to find the center in a piece of firewood every time. Mount some flat scrap wood to the lathe’s faceplate. Attach an acrylic piece to it using some double-faced tape. Chuck that in your lathe. Turn your acrylic to a disc. Using a 1/16″ bit in your tail stock chuck, drill a hole through that center-point. Scribe some concentric circles on to the disc at 1/2″³ intervals using a skew chisel. Position this center-finder over the end of your stock and adjust it until one of your circles is inscribed completely in a portion of the wood that is solid and usable. Using an awl or nail set, mark your center through the central hole in the disc.
There is still a lot to learn about woodworking but you will become an expert if you keep working on developing your skills. Luckily, you have seen some fantastic guidance to get you going. Now, you only have to continue your exploration and put to use what you have learned.
Leave a Reply