You probably don’t consider yourself a woodworker, or maybe just not a good one. But imagine what you could do if you were. Could you help build structures and buildings? Would you be able to make artistic pieces? Could you restore furniture? If any of these possibilities interest you, keep reading for knowledge you need on woodworking.
Safety is important when working with wood. Be sure to follow all safety directions when using power tools. Don’t take guards off a tool – they’re intended to keep you safe. The last thing you want to do is end up at the emergency room because of an accident.
You can use tape to catch excess glue. If you want to prevent oozing glue stains along joints, try clamping pieces together without using any glue. You just put tape on your joint, and then cut along it using a sharp blade. Separate your pieces, and then apply glue. After that, clamp them to each other again. Your glue will ooze on the tape instead of the wood. You can peel off the tape before your glue dries.
Stumped on a good woodworking project? Take a walk around your home. There are always things around your home that need fixing. Or you may see an area that could use something new that can be created with your skills. Let your house become the inspiration for what you really need.
Keep your woodworking tools well sharpened. Dull tools produce messy work and can be hard to use. Not only that, but it can injure you if you have to use excessive force to cut. A sharp tool gives you a cleaner and more efficient cut. You can really notice the difference.
You can prevent glue stains by placing masking tape along the joints of wood being adhered. First, tape the wood together along the joint, then use an Exacto knife to cut through the tape at the joint line. Following this, glue the pieces of wood together and clamp them. Just before the glue has dried completely, you can peel the tape off.
Save time in the shop by locating the most level spot on your floor and marking it with a brightly colored duct tape. When you do this, you can quickly and easily maneuver your mobile table saw into position for board cutting. You will not have to check the level and make time consuming minor adjustments every time you want to cut a board.
Of the surface of the wood in your project has been dinged or dented by accident, you need to remove the blemish before you finish it. If the fibers of the wood are only crushed, not torn, you can use steam to fix the problem. Fill the depression with a drop or two of water and use a hot iron over a damp cloth to level the dent.
Try to keep your work area clean as much as possible. There is going to be a lot of wood dust on the floor. Pieces of wood debris may be strewn about. When you keep your work area clean, you reduce the occurrence of injuries. Always keep a broom, dustpan and a large trash can on hand.
Avoid sanding with your fingertips. Instead, use a sanding block. If you can also use an electric sander. Better still, use an orbital sander. Sanding with your fingertips can cause sanding ruts. You may not notice these ruts until the project is finished. These are difficult or impossible to repair.
When you have skill in woodworking, you have the power to take a raw natural resource and make things with it. Use the tips, tricks and techniques to make your life a more enjoyable one. Build that deck you want behind the house, or restore an old piece of furniture, either for yourself or for profit.
Leave a Reply