You probably don’t consider yourself a woodworker, or maybe just not a good one. But imagine what you could do if you were. Could you help build structures and buildings? Would you be able to make artistic pieces? Could you restore furniture? If any of these possibilities interest you, keep reading for knowledge you need on woodworking.
You can make your crosscut guides using stair gauges. All you need to do is affix them to a square and then affirm that it is set as you would like the angles to be. Mark each notch. If you place them on the tongue you’re using for your carpenter square, that combo is a good crosscut guide for your circular saw.
Keep the floors safe in your woodworking shop. Dust builds up on the floor, making it dangerous for walking. Coat the slippery areas of your shop with a mixture of crushed walnut shells and paint. The walnut shells are just the right consistency to keep the floor rough enough for walking, even when sawdust builds up.
When learning a new woodworking technique, practice it over and over again. Repetition is the best way to learn these skills. So find some cheap wood (scrap wood works), and go at it for some time to hone your skills. This will make it so you’re less likely to make mistakes during important projects.
Before practicing advanced woodworking techniques, make sure you’ve got the basics down. Typically those advanced techniques rely on you knowing the basics like the back of your hand. If you don’t, you’ll more than likely find learning to be a very frustrating experience. So start slow, and work up from there.
A handy tool for every woodworking shop is a stair gauge. These are usually used for laying out stair jacks; however, you can also use it to clamp down your carpenter’s square. This will transform your carpenter’s square from a straight-line tool, into a straight guide for your saw. This is a good way to cut your wood in a straight line.
Many people use utility knives to cut veneer. This can be very dangerous; however, take heart, there is a better way. When cutting veneer, consider using a rotary cutting tool. These inexpensive tools can be purchased in your local fabric shop. Rotary cutting tools allow you to trim veneer to the perfect size.
When you find a nice level spot on your workshop floor for your table saw, it can be difficult finding the same spot after you put your saw away. When you do find a level spot, use duct tape on the floor so you know where to position your table saw next time you need it.
If you’re looking for that first woodworking project, how about starting with a simple box? In fact, that’s probably the most popular first woodworking project out there. Buy some cheap wood that you like, and design a box that could work around your home. Maybe it’s for writing utensils, or perhaps it’s for the kitchen? There are a lot of options.
If you are new to woodworking, stick with a cheap and effective tool bag. Many of the tools to start with are under a couple hundred dollars and very easy to find and use for basic projects. These tools include a benchtop tablesaw, a jigsaw or sabre saw, a circular saw, a random orbit sander, a corded or cordless drill, a fixed-base or plunge router, and a pipe and small bar clamps.
When you have skill in woodworking, you have the power to take a raw natural resource and make things with it. Use the tips, tricks and techniques to make your life a more enjoyable one. Build that deck you want behind the house, or restore an old piece of furniture, either for yourself or for profit.
Leave a Reply