The craft of woodworking can be applied to several end products. These include wood furniture, interior finishes such as built-in bookshelves and banisters and kitchen or bathroom cabinets. Most cabinets are built in an off-site cabinet shop and then the finished product is installed in the home by the builder.
Familiarize yourself with the tools that you are going to use. This is a very important tip for the beginner, but even more advanced woodworkers can benefit from it too. Lay out the tools and make sure that you know the workings of each one. If you’ve got a brand new tool to you, spend the time that you need with it.
Know wood characteristics before buying or using it in your projects that need staining. Low quality wood is considered “paint grade” and isn’t meant to be stained. Also, veneer and particleboard greatly differ. Particleboard absorbs a lot of stain while veneer doesn’t absorb much at all. It is crucial to get the perfect wood for your creation.
Many people use utility knives to cut veneer. This can be very dangerous; however, take heart, there is a better way. When cutting veneer, consider using a rotary cutting tool. These inexpensive tools can be purchased in your local fabric shop. Rotary cutting tools allow you to trim veneer to the perfect size.
Take advantage of several tools instead of trying to do all of your work on just one. A jig, a tablesaw, a bandsaw and a lathe all have their own uses. It is important that you know what each of these tools do and you use them accordingly while getting the job done.
Keep your tools and hardware organized. When you keep clutter to a minimum, it does more than just add discipline to your workshop. It also keeps distractions, hazards and time spent hunting down a misplaced item to a minimum. Keeping screws, nails and other hardware and accessories in one place neatly stored until needed makes your projects faster and keeps you safer.
Never cut any pieces of wood without checking for nails, screws and other metal. While donning a pair of goggles keeps your eyes protected, you are still at risk for other injuries. Inspect every piece of wood whether you are re-purposing it or using new lumber. You are better safe than sorry with this safety tip, and checking the boards only takes a few minutes of your time.
You can apply stain with either a brush, or a rag. Work the stain in against the grain, and with it as well. You need not be neat, just get a smooth, even coat on the wood. Then, wipe immediately for a lighter tone, or leave it on for up to fifteen minutes before wiping for a deeper tone.
If you are new to woodworking, you should familiarize yourself with the different types of wood that are available. Different woods have different uses and some require special tools. The more you know about the wood you will be working with, the more comfortable you will be when you begin your project.
You can make a sanding block even better. Cut a small slot about 3/8 of inch deep, a little less than an inch from the outside edge. Run it the entire length of the block. Now the sandpaper will fit into this slot easily, and it will stay in place more securely.
Cabinet making is a trade that requires great skill to produce beautifully detailed work. Most cabinet makers begin as an apprentice in an established shop to learn the basics of the trade. If you are someone who loves to work with wood and appreciate its beauty, this article can help you get started in the business.
Leave a Reply