Either you want to make things for sale or you just want to work with wood for the entertainment value. Your reasons do not matter. Woodworking is not terribly difficult, but it does take some know-how. The article below is a compilation of expert information and tips that you can put into practice immediately.
Clean your saw’s teeth before cutting lumber. To thoroughly clean your saw blade dip a shop rag into a little acetone and wipe the blade thoroughly. Additionally, using a piece of sandpaper that has a fine grit will remove any sap or gumminess from your skill saw’s cutting blades.
Make sure your work area is safe, well-lit and organized. Working with woods is difficult work, and it is dangerous work when your work area is dim and there are safety hazards in the area. Make sure there are no spills, tripping hazards and other safety hazards that are a disaster waiting to happen.
Always use the safety equiptment that came with any of your woodworking tools. You may feel that a sheild is getting in your way when you are sawing, but its purpose is to protect you from serious injury. If you feel tempted just think of what it would be like to lose a finger or worse.
If there is a joint in your work that does not fit together properly, this cannot be fixed with glue. While it may seem like the simple way to fix things, it will only work temporarily. The best thing to do would be to start over and be more careful the next time.
Stumped on a good woodworking project? Take a walk around your home. There are always things around your home that need fixing. Or you may see an area that could use something new that can be created with your skills. Let your house become the inspiration for what you really need.
Learn how to find the center in a piece of firewood every time. Mount some flat scrap wood to the lathe’s faceplate. Attach an acrylic piece to it using some double-faced tape. Chuck that in your lathe. Turn your acrylic to a disc. Using a 1/16″ bit in your tail stock chuck, drill a hole through that center-point. Scribe some concentric circles on to the disc at 1/2″³ intervals using a skew chisel. Position this center-finder over the end of your stock and adjust it until one of your circles is inscribed completely in a portion of the wood that is solid and usable. Using an awl or nail set, mark your center through the central hole in the disc.
Did you know that the teeth on a hacksaw face forward? Many people do not know this. It is the opposite of a wood saw. These saws are supposed to cut when pushed forward. Many times the blades are not labeled for correct installation. If this is the case, remember to put the teeth facing forward.
If dust and dirt get into the holes of a brad or nail gun while they are not in use, this can cause them to wear out more quickly. It is a good idea to plug the air inlet holes up with something to prevent anything from getting in there.
You can apply stain with either a brush, or a rag. Work the stain in against the grain, and with it as well. You need not be neat, just get a smooth, even coat on the wood. Then, wipe immediately for a lighter tone, or leave it on for up to fifteen minutes before wiping for a deeper tone.
Now that you now more about woodworking, you are ready to get started. Use what you’ve just learned, and you will do quite well. Enjoy the process as you improve your skills and make wonderful creations. You are about to find out just how much of a joy woodworking really is!