Woodworking can be a great hobby for people from all walks of life. Whether you are an expert, or are just getting started, there is always something new for you to learn about the woodworking skill. If you like to learn more about this hobby you should read the article that follows below for some great advice.
Keep the floors safe in your woodworking shop. Dust builds up on the floor, making it dangerous for walking. Coat the slippery areas of your shop with a mixture of crushed walnut shells and paint. The walnut shells are just the right consistency to keep the floor rough enough for walking, even when sawdust builds up.
If you enjoy doing woodworking as a hobby, try to use all the materials that you buy and throw away as little as possible. Scrap pieces of plywood or hard wood can be used as sanding blocks for future projects. You can also use scrap wood for wooden dowels in furniture making.
Remember the quote, “Measure twice, cut once.” When it comes to cutting wood, you always want to ensure you have the right measurements before you begin cutting. Otherwise, you will have to buy more wood, which will cost you a lot of money. You can avoid this dilemma by ensuring proper measurements.
Sometimes a little bit of glue is better than a clamp. Every woodworking shop should have a hot glue gun. Hot glue will hold small pieces better than any clamp ever could, if you could even maneuver one in place. When you are done, just gently pry loose with a putty knife.
Plan out your project and go over it a few times before you start. This will help prevent you from making mistakes that will ruin your project. You do not want to start it all over again, so plan it out well before you cut, screw or nail anything together.
Seek out wood that has been recycled. Many places will get rid of scraps that you can use. Home improvement stores, floor shops and other such places usually discard any unused wood. Look for wood that you can use for projects. This can help you save money.
You can make a sanding block even better. Cut a small slot about 3/8 of inch deep, a little less than an inch from the outside edge. Run it the entire length of the block. Now the sandpaper will fit into this slot easily, and it will stay in place more securely.
Attached a small magnet to the bottom of your hammer’s handle to hold several nails when working above your head or on a ladder. This simple technique allows you to keep your nails handy and avoid climbing up and down the ladder when you are working above your head.
Fumes from oil-based stains can be harmful to animals, as well as humans. To avoid fumes, try using a water-based stain. Water-based stain comes in a wide variety of colors, even more than their oil-based counterparts. And the application process is the same whether you are using oil, or water-based stain.
Clean tools last longer; therefore, it is important to clean your tools after each use. Dip a shop rag into a small amount of acetone and wipe each tool to remove any build-up. Afterwards, dip a different shop rag into machine oil and wipe the metal of each tool to help prevent rusting.
As you read at the beginning of this article, there is so much that you can learn about woodworking that you will never know everything. However, even though that is a fact, there is no reason to not try. Now that you read this article you know a little more, and continuing to learn will only lead you to being a better woodworker.