It is very exciting getting into the art of woodworking. However, with it being such a large field, many people can feel a little uneasy trying to start out. Don’t let this happen to you. Instead, embrace the following tips, and get started today putting your skills to work with some wood.
Take care when using power tools. If you are new to woodworking, be very careful when you are operating power tools for the first time. Read the manual thoroughly, and if possible, have someone with experience demonstrate how to use it properly. This will ensure that you don’t have a nasty accident during your woodworking project.
If you would like to start woodworking as a hobby or a business, always buy the highest quality tools that you can find. While you may be able to find cheaper tools, they will end up breaking during your project. Spend the extra money and buy a quality tool that will last a lifetime.
Do not make the mistake of buying woodworking supplies based on the price alone. This can turn out to be a mistake that will cost you more in the end. If the supplies you buy are not very good quality, they will wear out sooner than more expensive tools, which means you will have to replace them much sooner.
Buy nails in the right size and of the right material for each job. Very large nails can cause wood to split, which will prevent it from holding well. A nail that isn’t big enough won’t keep the wood together. The right size is a must.
Always remember the rule of measuring twice and cutting once. You are human, which means that mistakes are inevitable. However, you can prevent measurement mistakes from turning into cutting mistakes when you measure two or three times. That is going to spare you serious waste, not just in terms of wasted wood, but also money and time.
Always keep your work area clean and safe, even when you are not actually there. Leaving out pieces of lumber with nails in them or even power tools that are easily activated in your yard can be dangerous. You never know when animals or even neighborhood children might come romping through and hurt themselves.
Learn how to find the center in a piece of firewood every time. Mount some flat scrap wood to the lathe’s faceplate. Attach an acrylic piece to it using some double-faced tape. Chuck that in your lathe. Turn your acrylic to a disc. Using a 1/16″ bit in your tail stock chuck, drill a hole through that center-point. Scribe some concentric circles on to the disc at 1/2″³ intervals using a skew chisel. Position this center-finder over the end of your stock and adjust it until one of your circles is inscribed completely in a portion of the wood that is solid and usable. Using an awl or nail set, mark your center through the central hole in the disc.
Are you finding it hard to be able to reach a screw that you need to tighten? Look to your toolbox. Just grab a 12-point socket set. Place the socket on the screwdriver and place it atop a ratchet.
Never allow someone to watch while you are woodworking without wearing the same gear that you are wearing. Being anywhere near the tools is a hazard, even if they are not using them. Wood or parts of the tool could fly into the air and strike them just as they could you.
Woodworking is a craft enjoyed by young and old alike and has been treasured for centuries. In order to get the most out of it, you must be working towards honing your skills. So, use the tips that have been discussed to help you get going in the right direction today.