If you have any unique, hand-made furniture, you know how beautiful woodwork can be. When you’d like to tackle such a project for yourself, you need to have the right knowledge in place to be able to find success. This article provides you with some tried and tested tricks for your next project.
Woodworking can be a fun, and satisfying, hobby. However, it is very important to play it safe when working with tools, substances that cause fumes and other common dangers of the craft. Be sure to wear safety glasses, allow plenty of fresh air for ventilation when using oil-based products and always read the directions before you start anything!
Gel stains are great for furniture. Liquid stains have a tendency to run but gel stains will stay in place better, without running. Furthermore, since a gel stain is thicker it tends to remain constant through the application process, which lets it be more even on the furniture.
Become more accurate by using a drafting square. If you need an accurate square that’s about 2″ to 3″, you have limited options. Drywall squares tend to be very inaccurate. With carpenter squares, you have to hook them onto your work piece’s edge. A drafting square can be easily used if you happen to have one lying around. If you don’t, they are pretty cheap to find at art stores. They are incredibly accurate and as useful as a tape measure.
When you install your hacksaw blade, make sure the teeth face forward. They are designed to cut when pushed using a forward stroke instead of a pulled stroke. Some of these blades have arrows pointing toward the handles that show the correct way to install them. Install it making sure it is tight and cannot bend. When you do lots of cutting, your blade heats up and expands, so make sure you tighten it before it begins bending.
If there is a joint in your work that does not fit together properly, this cannot be fixed with glue. While it may seem like the simple way to fix things, it will only work temporarily. The best thing to do would be to start over and be more careful the next time.
Remember the quote, “Measure twice, cut once.” When it comes to cutting wood, you always want to ensure you have the right measurements before you begin cutting. Otherwise, you will have to buy more wood, which will cost you a lot of money. You can avoid this dilemma by ensuring proper measurements.
When you need accurate measurements in the 3-foot range, use a drafting square. These are relatively cheap and can be found at any art supply store. They are perfectly straight and extremely accurate. They are less cumbersome than a framing square and are also longer. This will become your go-to tool in your woodworking shop.
Always check your tools before you begin using them. Woodworking with a faulty or overused tool can easily lead to a serious injury or destruction of your materials. To make sure that this does not happen to you take the time to thoroughly inspect your tools from top to bottom.
Only cut using sharp tools. Older and dull tools result in tear-outs and even chipping, which is frustrating and a waste of time. Sharp tools means you get clean cuts quickly. You’ll also spend a lot less time sanding things to get just the right look and fit that you need.
As you plan out your next project, you can use these tips to master your technique. Each has been written to ensure you can easily integrate them into your technique. As long as you make use of them, you will find the time you spent reading this article was worth it.
Leave a Reply