You don’t have to be a genius to work with wood. The fact is that all you need to be able to do is lift a hammer and measure accurately, along with having a good imagination. Of course, your skills need to improve, and the tips below will help you to do just that.
Stair gauges may be just the ticket for crosscut guides. Clamp them on the carpenter’s square. Then use a pencil to mark the notches. You have a great crosscut guide when you put each of them on the carpenter’s square together.
Try using duct tape to create a level spot. If you’ve used your table saw on a base that’s mobile, you should be able to easily pull it in and out. To really finish it up, find a level spot on your floor. This also helps you saw boards without obstruction. Mark your wheel positions using duct tape that is brightly colored, and then roll the saw to that same flat spot each time you need to saw.
Keep all of your woodworking tools in a safe and dry place. You want to be sure that your tools are not in reach of children, as well as that they will be safe from moisture and other elements that can cause them to degrade at high rate. Follow this rule and your tools will last a long time.
When you install your hacksaw blade, make sure the teeth face forward. They are designed to cut when pushed using a forward stroke instead of a pulled stroke. Some of these blades have arrows pointing toward the handles that show the correct way to install them. Install it making sure it is tight and cannot bend. When you do lots of cutting, your blade heats up and expands, so make sure you tighten it before it begins bending.
If you have your own table saw, you will eventually have to crosscut some wood. This can bring your fingers very close to the saw guard and blade. If the saw kicks back, you could be headed to the hospital. It is best to cut a block of wood to push the wood through the saw with.
Always do a dry fit prior to gluing two pieces of wood together. If you adjust things after applying glue, you might cause some damage. Dry-fits help you see what components go in what locations.
Glue can cause nasty stains on your finished work. You can eliminate stains easily using a piece of tape. First, clamp your wood together without any glue. Put a piece of tape over the joint. Cut the tape on the joint with a sharp knife. You can now clamp the wood together with glue and any excess will ooze onto the tape, not the wood.
Learn more about different kinds of wood and their characteristics. All wood is not the same. Staining looks different on various types of wood. Different woods will splinter in unique ways. And, you will notice a plethora of grains. All of these characteristics factor into your woodworking projects.
When you need accurate measurements in the 3-foot range, use a drafting square. These are relatively cheap and can be found at any art supply store. They are perfectly straight and extremely accurate. They are less cumbersome than a framing square and are also longer. This will become your go-to tool in your woodworking shop.
Once you master the basics of woodworking, these tips can help you get to the next level of skill. That will open you up to new projects you never thought you would be able to accomplish. The more you practice, the better you will become, so continue to enjoy this hobby as often as possible.
Leave a Reply