When it comes to woodworking, there is a vast world to learn about. From types of wood to which tools are best, you will find that there is no end to your education. To learn some more about your favorite pastime, this article provides you with helpful hints to help you be more successful.
When using stains or finishes, be sure to stir them, rather than shake them. These can settle can must be stirred. However, shaking can cause bubbling and prevent a thorough mixing of the product. Stir completely, allowing all settlement to blend evenly and smoothly.
When you are working on a project, be sure to face your light directly on your working area. The bright light will enable you to detect any drips or runs you may not see otherwise. Missed areas will also be more visible. Be sure to always work in a well-ventilated area as well.
When sanding a piece of lumber, a lot of sawdust and debris is produced. To help remove those bits of dust and debris from your project vacuum the area. Then, remove the remaining debris using a tack cloth. Wipe both sides of the lumber to remove all traces of debris for best results.
Whenever you work with wood, wear a pair of safety glasses and a dust mask to keep yourself safe. When cutting or even hammering into wood, pieces can fly up into your eyes or be breathed in. This can lead to health issues which can end your enjoyment of this pursuit for good.
Know all about the wood you are getting prior to purchasing it, especially if you plan to stain it. Some woods are only paint grade, while stain grade woods are much better for staining. Also realize that veneer and particleboard are different. Particleboard will absorb too much stain, veneer might not absorb enough. Your project will turn out better if you make sure you get the right wood.
Be sure your blade sharp prior to trying to cut. A blade that has become dull can make it almost impossible to saw as you need to. This can cause costly mistakes in your project. Checking your saw blades before hand is a lot easier than losing money and time.
If you are cutting, sanding, or finishing something small, get out your hot glue gun. Affix the item you are working on to the end of a pedestal stick. Hot glue holds better than a clamp, and small objects are impossible to clamp anyway. Just be careful when pulling the piece off to avoid tearing the back side of the wood.
Learn about using pilot holes. This is pretty simple to do. When driving a screw or hammering a nail into a little piece of wood or getting pretty close to the edge of a piece, it tends to split. Sometimes it’s unavoidable to put a fixing into a place like this. However, drilling a hole through the joint that’s a bit smaller than the fixing can prevent it from splitting.
Only cut using sharp tools. Older and dull tools result in tear-outs and even chipping, which is frustrating and a waste of time. Sharp tools means you get clean cuts quickly. You’ll also spend a lot less time sanding things to get just the right look and fit that you need.
Whether you prefer to do it in your spare time or enjoy it as your career, woodworking is truly an enjoyable thing for you to do. That is why you found this article and have gained the knowledge you absorbed today. Take that new data and start using it as soon as possible.
Leave a Reply