The craft of woodworking can be applied to several end products. These include wood furniture, interior finishes such as built-in bookshelves and banisters and kitchen or bathroom cabinets. Most cabinets are built in an off-site cabinet shop and then the finished product is installed in the home by the builder.
Don’t neglect sanding your wood. Sanding may be tedious, but the quality of your workmanship will suffer if you leave the scrapes and nicks where they are. Not to mention, those scratches and nicks absorb more stain and paint, making them stand out more, and making your work look shoddy.
Choose the right type of wood for the project that you are doing. Some pieces require a durable hardwood, while others can be done with a softer type of wood. Learn as much as you can about the different varieties of wood before beginning any woodworking project.
Use hot glue instead of clamps for little things. When cutting, filing, sanding, or finishing something small, use the hot glue gun to glue the piece to your pedestal stick. The glue holds holds just like clamps, if not better than clamps. It also works great for things that clamps will not work on. When you finish your project, loosen it gently with a putty knife.
Keep the floors safe in your woodworking shop. Dust builds up on the floor, making it dangerous for walking. Coat the slippery areas of your shop with a mixture of crushed walnut shells and paint. The walnut shells are just the right consistency to keep the floor rough enough for walking, even when sawdust builds up.
Dust can ruin the finish of any woodworking project. Keep dust away from your projects and workbench by vacuuming it up. If you blow or brush it away, it will just land somewhere else, likely back on your project. Also, use a damp cloth to wipe all surfaces before you begin top-coating, or staining.
Visualize your woodworking project from start to finish before taking any tool to the wood. Let your brain and imagination help you get used to what you’re about to do. In fact, when you visualize, you’ll be much less likely to make costly mistakes during the middle of a project.
Before you cut into a piece of wood, you need to inspect it to make sure there are not any pieces of metal in the wood. Screws, nails, staples and other metallic object will not only damage your blades, but also pose a safety hazard. Always inspect the wood before you cut.
When you find a nice level spot on your workshop floor for your table saw, it can be difficult finding the same spot after you put your saw away. When you do find a level spot, use duct tape on the floor so you know where to position your table saw next time you need it.
You can apply stain with either a brush, or a rag. Work the stain in against the grain, and with it as well. You need not be neat, just get a smooth, even coat on the wood. Then, wipe immediately for a lighter tone, or leave it on for up to fifteen minutes before wiping for a deeper tone.
Attached a small magnet to the bottom of your hammer’s handle to hold several nails when working above your head or on a ladder. This simple technique allows you to keep your nails handy and avoid climbing up and down the ladder when you are working above your head.
Cabinet making is a trade that requires great skill to produce beautifully detailed work. Most cabinet makers begin as an apprentice in an established shop to learn the basics of the trade. If you are someone who loves to work with wood and appreciate its beauty, this article can help you get started in the business.