Either you want to make things for sale or you just want to work with wood for the entertainment value. Your reasons do not matter. Woodworking is not terribly difficult, but it does take some know-how. The article below is a compilation of expert information and tips that you can put into practice immediately.
Try making sanding blocks that are reusable on your own. Make a list of each sandpaper grit that you typically use, and then cut a full six blocks for each from scrap plywood, 3/4″ thick. Be certain they are approximately 2 1/2 inches by 4 1/2 inches. Spray your adhesive on the cork tile and the block of wood. Put one block on the cork, and then cut it flush with a knife. Then, spray your sandpaper with adhesive and apply it to the cork. Cut the sandpaper flush and label the block.
Try using duct tape to create a level spot. If you’ve used your table saw on a base that’s mobile, you should be able to easily pull it in and out. To really finish it up, find a level spot on your floor. This also helps you saw boards without obstruction. Mark your wheel positions using duct tape that is brightly colored, and then roll the saw to that same flat spot each time you need to saw.
When working with wood, it is important that you have a lot of patience when it comes to the finishing process. This is just as important as the actual woodworking. Things like gluing edges and sanding the wood down take time, and you will only mess things up if you try to rush through this process.
Make sure your workbench is the proper height. It really can make a big difference. It needs to fit you and how you work. Usually if you are around 5’6″ to 5’9″ you probably need one that is between 33″ and 36″ high. If you are 5’10” or taller, you may need one that is between 35″ and 37″ high. Use your bench at its current height to determine if you need to change it to work better for you.
If you have a high skill level when it comes to woodworking you may want to think about taking some time to share your knowledge with others. You can keep it simple by recording what you do step-by-step or you could take it to a higher level and teach a class.
If there is a joint in your work that does not fit together properly, this cannot be fixed with glue. While it may seem like the simple way to fix things, it will only work temporarily. The best thing to do would be to start over and be more careful the next time.
Learn all about the wood you are working with and its particular characteristics. Wood varies from type to type. Different types of wood will stain differently. Splintering varies among cuts. You will also see different types of grains. All of this will become factors in your woodworking project.
Always clean up sanding dust thoroughly before staining or applying a topcoat. If you want a smooth finish, dust is your enemy. Use a vacuum over blowing dust into the air because it settles back onto the wood, and use a damp cloth to ensure all dust is removed from the wood in your final cleanup prior to staining or applying a top coat.
Now that you now more about woodworking, you are ready to get started. Use what you’ve just learned, and you will do quite well. Enjoy the process as you improve your skills and make wonderful creations. You are about to find out just how much of a joy woodworking really is!